FRAMING AND INSTALLATION
BATH MAY ONLY BE INSTALLED ABOVE THE FLOOR LINE IN A RECESS TYPE INSTALLATION, AS SHOWN IN RECESS INSTALLATION DIAGRAM.
THE FOLLOWING PROCEDURE MUST BE USED FOR ALL INSTALLATIONS: STRINGER OR PIER HEIGHT SHOULD BE AS INDICATED. THE SUMP OF THE BATH IS SUPPORTED BY INTEGRAL FEET AND NO ADDITIONAL SUMP SUPPORT IS REQUIRED. ONCE THE BATH IS IN PLACE, THE FEET SHOULD BE SHIMMED ACCORDINGLY, SO THAT THE RIM OF THE BATH CONTACTS THE STRINGER OR PIER BUT SUPPORTS NO WEIGHT. ANY FINISH MATERIAL, SUCH AS TILE OR WALL BOARD, MUST BE
LOCATE STUDS AS REQUIRED. INSURE ROUGH DIMENSIONS ARE PROPER, PLUMB AND SQUARE. FOR REAR MOTOR
MOUNT WHIRLPOOLS, PROVISION MUST BE MADE IN ALL INSTALLATIONS FOR AN ACCESS OPENING FOR SERVICING PUMP AND CONTROLS.
TYPICAL RECESS INSTALLATION
1 X 3 LEVELING STRINGER
2 X 4 STRINGER SUPPORT
STUD FLANGE BRACKET INSTALLATION
BATH
FLANGE DRYWALL
533mm
(21)
1527mm
|
|
|
| m |
|
|
|
|
| m |
|
| |
| 5 |
|
|
| ||
7 |
|
| ) |
|
| |
7 |
|
|
|
|
| |
|
|
|
| 0 |
| m |
|
| 3 |
| |||
| ( |
|
| m | ||
|
|
|
|
| 3 |
|
|
|
|
| 1 | ) | |
|
|
|
| 8 |
| |
|
|
|
|
|
| 2 |
|
|
|
|
| 3 | |
|
|
|
|
| ( | WIDTH |
|
|
|
|
|
| |
|
|
|
| TUB |
| |
1 X 3 X 8 LEVELING
305mm
(12)
SCREW
STUD
FLANGE
BRACKET
WALL BOARD
TILE
STRINGER
610mm
(24)
BATH
STUD
ADHESIVE
SEALANT
BATH
LEVELING STRINGER
WHIRLPOOL ONLY:
UNLESS AN ACCESS OPENING OF AT LEAST 305mm X 610mm(12" X 24") IS PROVIDED, WARRANTY SERVICE WILL NOT BE PERFORMED.
SECURE THE BATH TO THE STUDS AS SHOWN USING THE SCREWS AND BRACKETS PROVIDED - SEE STUD FLANGE BRACKET INSTALLATION
STUD FLANGE BRACKET INSTALLATION
PROVIDED WITH THE BATH IS A PACKAGE OF (4) FOUR STUD FLANGE BRACKETS AND (8) EIGHT SCREWS. INSTALL BRACKETS AND SCREWS AS SHOWN IN WALL BRACKET INSTALLATION DETAIL. TWO BRACKETS SHOULD BE LOCATED EVENLY ACROSS THE BACK TILE FLANGE AND INSTALL ONE BRACKET ON EACH END OF THE BATH, TOWARDS THE FRONT END OF THE TILE FLANGE. THIS WILL ALLOW TILE FLANGE TO BE HELD SECURELY AGAINST STUDWALL OF RECESS INSTALLATION.
(2) | SPIC AND SPAN® IS A REGISTERED TRADEMARK OF PROCTER & GAMBLE |
