Dynalink RTA1335 setup guide Q3. Need to install router on a network that does not use

ADSL 2+ 4-Port Modem Router Quick Set-up Guide

•If there is no designated ADSL jackpoint, any jackpoints may be used. Connect the router directly into a jackpoint, or through the port marked MODEM on a filter.

2.If the DSL light is on, but the PPP light is off, check that:

•The Internet account User Name & Password are correctly entered. Go to the Quick Start menu as described in Section 5 – Getting On-line. Re-enter user name and password in the exact format as specified by the ISP.

•Your ADSL account has been activated with the ISP.

3.If the PPP light is on, verify the network configuration of computer and router. If you still cannot browse, perform a PING test as described in Q1-2. If there is response, now use these addresses:

(A) Ping www.dynalink.co.nz (or any valid web address)

(B) Ping 205.178.180.16 (or any valid public IP address)

If both (A) & (B) reported failures such as “request time out”, and you assigned an IP address to your computer manually, refer to procedure (2) of Section 4 and the relevant sections of the User’s Manual. Check that the router’s IP (192.168.1.1) is entered as gateway & DNS.

If (A) fails but (B) shows a response, this is probably a DNS problem. Refer to procedure (2) of Section 4 and the relevant sections of the User’s Manual. Enter the router’s IP (192.168.1.1) as DNS. If the ISP specifies a set of DNS address, use the address.

If both (A) & (B) show responses, you are on line. The problem may be with your browser setting. Try returning any custom settings of the browser to default. If you have a personal firewall, disable it to see if it makes any difference. Also you may try shutting down the computer and restarting.

Q3. Need to install router on a network that does not use 192.168.1.0

If the existing network already has a DHCP server, disconnect one computer from the network. Connect the computer to the router. The host computer will be assigned 192.168.1.2. You can change the router’s IP so that it is consistent with the network. Disable DHCP on the router.

Q4. Browsing is fine but I cannot run certain applications.

You need to set up virtual servers or DMZ host. See Section 7 - Firewall, port forwarding, DMZ & traffic restrictions.