KNOWING YOUR SEWING
6While holding the end of the thread, gently press the foot controller to wind the thread around the bobbin a few times. Then stop the machine.
7Trim the excess thread above the bobbin.
1
11 cm (1/2 inch)
CAUTION
●Make sure you follow the instructions carefully. If you do not cut the excess thread completely before winding the bobbin, when the thread runs low it may tangle around the bobbin and cause the needle to break.
8Press the foot controller to start.
9When the bobbin seems full and begins spinning slowly, take your foot off the foot controller.
0Cut the thread, slide the bobbin winder shaft to the left and remove the bobbin.
Note
●When the sewing machine is started or the handwheel is turned after winding the thread around the bobbin, the machine will make a clicking sound; this is not a malfunction.
●The needle bar does not move when you slide the bobbin winder shaft to the right.
CAUTION
●Not winding the bobbin properly may cause the thread tension to loosen, and may break the needle.
1 2
1Wound evenly
2Wound poorly
Lower threading
Install the bobbin wound with thread.
•For more details on using the
CAUTION
●Make sure you turn off the machine while threading. If you accidentally step on the foot controller and the machine starts to sew, you could be injured.
1Prepare the bobbin wound properly before threading the lower thread.
•See page 13 for the details about bobbin winding.
2Raise the needle by turning the handwheel toward you (counterclockwise) and raise the presser foot lever.
3Remove the bobbin cover by sliding it and lift toward you.
1
1Bobbin cover
15
