American Standard 2998.010, 3417.016 dimensions Cadet Right Height 10 ROUGH-IN Elongated Toilet

CADET™ RIGHT HEIGHT™ 10" ROUGH-IN ELONGATED TOILET

VITREOUS CHINA

CADET™ RIGHT HEIGHT™ 10" ROUGH-IN ELONGATED TOILET

❑2998.010

•Vitreous china

•Low-consumption (6.0 Lpf/1.6 gpf)

•16-1/2" rim height for accessible applications

•10" roughing-in

•Elongated siphon action jetted bowl

•AquaForce flushing technology

•Fully glazed 2" trapway

•Close-coupled tank with raised lip detail on tank cover

•Color-matched trip lever

•Speed Connect® tank/bowl coupling system

•Sanitary bar on bowl

•2 bolt caps

•100% factory flush tested

❑3417.016 Bowl

❑4110.016 Tank

Alternate Tank Configurations Available:

❑4110.600 Tank complete with tank cover locking device

❑4110.800 Tank complete with trip lever located on right hand side

Nominal Dimensions:

705 x 495 x 813mm

(27-3/4" x 19-1/2" x 32")

Fixture only, seat and supply by others

Compliance Certifications -

Meets or Exceeds the Following Specifications:

•ASME A112.19.2M for Vitreous China Fixtures - includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions

70mm (2-3/4)

FINISHED WALL

705mm (27-3/4)

19mm ± 6mm	495mm
(3/4 ± 1/4)
	(19-1/2)

184mm (7-1/4)

470mm (18-1/2)

C/L OF SEAT POST HOLES 140mm (5-1/2 CENTERS)

			813mm
		SUPPLY	(32)
		AS
		REQ'D
		419mm
		(16-1/2)
		*254mm(10)	375mm
			(14-3/4)
		152mm
	16mm	(6)
	(5/8)	FINISHED
178mm	311mm	FLOOR	235mm
(7)	(12-1/4)		(9-1/4)
254mm	C/L OF OUTLET
(10)

To Be Specified:

❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver

❏Fawn Beige ❏ Black

❏Seat: American Standard #5324.019 “Rise and Shine” solid plastic closed front, seat with cover.

❏Seat: American Standard #5311.012 “Laurel” molded closed front seat with cover.

❏Alternate Seat:

❏Supply with stop:

© 2008 AS America Inc.

NOTES:

THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 254mm (10") FROM FINISHED WALL TO C/L OF OUTLET.

SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY.

*DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2.

These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.

MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USABLE BUILDING FACILITIES-CHECK LOCAL CODES.

K82

Revised 2/08