Installation Instructions
3821.6XX
SINGLE CONTROL KITCHEN
FAUCET AND CAST SPOUT
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds
Certified to comply with ANSI A112.18.1M
M968188 REV . 1 . 1
TOOLS REQUIRED
|
|
| Phillips Screwdriver |
Channel Locks | Adjustable Wrench | Plumbers' Putty or Caulking | Regular Screwdriver |
1 INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON |
|
| |
CAUTION | Turn off water at |
|
|
main supply. |
|
|
(A) Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON (1). Insert supply HOSES (3) and SHANK (4) through hole of ESCUTCHEON (1) and mounting surface. Make certain the
is properly seated in recess of SPOUT BASE. Follow mounting instructions below to secure faucet to mounting surface.
(B) Installation less ESCUTCHEON (1). Remove ESCUTCHEON (1) , feed FAUCET HOSES (3) and SHANK (4) through DECORATIVE FLANGE (10). Push FLANGE (10) so the raised step fits into recess of SPOUT BASE.
Push
Insert SUPPLY HOSES (3) and SHANK (4) through mounting hole and seat DECORATIVE FLANGE (10) onto sink or mounting surface.
Assemble RUBBER WASHER (5), BRASS WASHER (6), and threaded LOCKNUT (7) onto SHANK (4) from underside of sink or mounting surface. Hand tighten LOCKNUT (7) and check that rotation of HANDLE (8) from HOT to COLD is centered.
Use a screwdriver to tighten SCREWS (9) on LOCKNUT (7). Work your way around LOCKNUT (7), tightening the screws slightly each time until all are snug to ensure even pressure.
AB
|
| 8 | 8 |
|
|
| |
SPOUT BASE |
|
|
|
| 2 |
| 10 |
|
|
| |
1 |
|
| 11 |
|
|
| |
|
|
| 4 |
P U T T Y |
|
| 3 |
|
| 3 | |
|
|
| |
|
|
| 4 |
| 5 |
| 6 |
9 | 7 |
SINK OR
MOUNTING
SURFACE
5
6
9 | 7 |