Cisco Systems 2960 specifications 1 Installing the Mounting Screws on Top of a Desk or Shelf

Chapter 3 Switch Installation (8-Port Switches)

Installing the Switch

Figure 3-1 Installing the Mounting Screws on Top of a Desk or Shelf

2

3

1

1

2

210096

Screw template 3 Desk or shelf

Screws

Step 3 Peel the adhesive strip off the bottom of the screw template, and attach it to the top of the desk or shelf.

Step 4 Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the three screw template slots.

Step 5 Insert three screws in the slots on the screw template, and tighten them until they touch the top of the screw template.

Step 6 Remove the screw template from the desk or shelf.

Step 7 Place the switch onto the mounting screws, and slide the switch forward until it locks in place, as shown in Figure 3-2.

Note We strongly recommend that you allow at least 3 inches (7.6 cm) of clearance around the ventilation openings to prevent airflow restriction and overheating.

Do not stack switches or place switches side-by-side unless they are separated on all sides with at least 3 inches (7.6 cm) of clearance from each other.

Do not place any items on the top of the switch.

Catalyst 2960 Switch Hardware Installation Guide

3-8 OL-7075-05