Cisco Systems 2960 specifications 3-13, 6 Installing the Switch On a Wall

Chapter 3 Switch Installation (8-Port Switches)

Installing the Switch

Step 4 Attach the screw template to the wall.

Step 5 Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the three screw template slots.

Step 6 Insert three screws in the slots on the screw template, and tighten until they touch the top of the screw template.

Step 7 Remove the screw template from the wall.

Step 8 Place the switch onto the mounting screws, and slide it down until it locks in place, as shown in Figure 3-6.

Figure 3-6 Installing the Switch On a Wall

1

3

2

1

2

2

2

Switch 3 Slides on this way

Screw

157829

After the switch is mounted on the wall, do these tasks to complete the installation:

1.Power on the switch. See the “Verifying Switch Operation” section on page 3-6.

2.Connect to a 10/100 or 10/100/1000 port, and run Express Setup. See the switch getting started guide for instructions.

Catalyst 2960 Switch Hardware Installation Guide

OL-7075-05 3-13