PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING .

WARNING! If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance

•Do not touch any electrical switch

•Do not use any phone in your building

•Immediately call your gas supplier from a neighbors phone. Follow the gas supplier’s instructions.

•If you can not reach your gas supplier, call the fire department.

IMPORTANT: Save these instructions for the Local Gas Inspector’s use.

INSTALLER: Please leave these Installation Instructions with the unit for the owner.

OWNER: Please retain these instructions for future reference.

The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70

The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 5 psi (35 kPa).

The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 5 psi (35 kpa).

WARNING! Disconnect Power before installing. Before turning power ON, be sure that all controls are in the OFF position.

IMPORTANT! Installation must conform with local codes.

IMPORTANT INSTALLATION INSTRUCTIONS INTRODUCTION

Capital’s PRECISION Series Gas Ranges are tested and approved in accordance with ANSI Z21.1b-2003/ CGA IR 58, 1995, Household Cooking Appliances. It is STRONGLY RECOMMENDED that this appliance be installed in conjunction with a suitable overhead VENT HOOD. Due to the high heat output of this unit, particular attention should be paid to the hood and ductwork installation to assure it meets local building codes.

NOTE: Local building codes vary. Cabinet storage above the unit should be avoided to prevent the risk of accidental fire or burns.

In the commonwealth of massachusetts, gas connection must be performed by a licensed plumber or gas fitter.

IMPORTANT! Installation, electrical connections, grounding and gas connections must comply with all applicable codes. In the absence of local codes, the unit should be installed in accordance with the National Fuel Gas Code ANSI Z223.1/NFPA54- CURRENT ISSUE and National Electrical Code ANSI/NFPA70-CURRENT ISSUE.

Be sure the unit being installed is set up for the type of gas supplied. The Gas range shipped from the factory is set for Natural Gas or LP (Propane), depending on the specific model ordered.

ENSURE THAT THE RANGE IS COMPATIBLE WITH GAS SUPPLY AT THE INSTALLATION SITE BEFORE PROCEEDING FURTHER. Contact the unit to the dealer if it is not set for the proper gas supply available at the installation site.

I M P O R T A N T I N F O R M A T I O N

IMPORTANT! A back guard must be utilized when there is less than 12” horizontal clearance between combustible materials and the back edge of the range. The Capital PRECISION SERIES Low Back or High Shelf must be ordered separately and installed at the rear of the range. For island installations and other installations with more than 12” clearance, our stainless steel Island Trim is suitable to cover the back guard mounting flanges.

GAS SUPPLY

NATURAL GAS: 6-inch water column. (14.9mb) Min., 8 inch (20mb) nominal

PROPANE GAS: 11-inch water column. (27.4mb), 14 inch (37mb) maximum

ELECTRIC POWER SUPPLY

GSCR30, GCR30 models – 120 VAC, 60 HZ, 1 PH., 20 Amp Circuit

GSCR36, GCR36 models – 120 VAC, 60 HZ, 1 PH., 20 Amp Circuit

GSCR48, GCR48 models – 120 VAC, 60 HZ, 1 PH., 20 Amp Circuit

GSCR60 Models 120 VAC, 60 HZ, 1 PH, 20 Amp

STEP 1: UNPACKING, MOVING and PLACING the

RANGE

CAUTION: Proper equipment and adequate manpower must be used in moving the range to avoid damage to the unit or the floor. The unit is heavy and rests on stainless steel legs.

•It is strongly recommended that after removing the packing material, remove the door(s), top grates, oven racks, front kick plate and drip pan(s) to facilitate lifting and easier handling.

•Remove the outer carton and packing materials from the shipping base. The all gas ranges are held to the skid by three (3) bolts. After removing the bolts the range must be lifted and removed from the skid.

25

Page 25 Page 27
Page 26
Image 26
Capital Cooking Precision Series P O R T a N T I N F O R M a T I O N, Important Installation Instructions Introduction
Page 25 Page 27

Precision Series specifications

Capital Cooking is renowned for its commitment to creating high-quality, professional-grade cooking appliances, and the Precision Series stands out as a testament to that legacy. This series merges functionality with aesthetic appeal, catering to both amateur chefs and culinary professionals.

The Capital Cooking Precision Series offers features that enhance cooking efficiency and precision. One of its most notable aspects is the powerful cooking system. The series incorporates high-BTU burners that provide exceptional heat output, ensuring that food can be cooked quickly and evenly. With options ranging from 15,000 to 25,000 BTUs per burner, the precise adjustment of heat levels becomes effortless, allowing users to tackle a variety of cooking methods from searing to simmering.

Another hallmark of the Precision Series is its dual fuel option. This means that users can enjoy the precision of gas cooking with the consistent power of an electric oven. This combination allows for superior temperature control and even cooking, making it ideal for baking and roasting. Additionally, the electric convection oven feature ensures that hot air circulates evenly, resulting in perfectly baked goods and roasted meats.

The build quality of the Precision Series is also noteworthy. Crafted from high-grade stainless steel, these appliances not only offer durability but also add a sleek, modern look to any kitchen. The heavy-duty construction withstands the rigors of daily use, ensuring longevity that appeals to serious cooks.

Ease of use is enhanced with ergonomic controls and a user-friendly interface. The series includes customizable options like griddle and grill attachments, giving cooks the flexibility to expand their culinary repertoire. Furthermore, the integrated LED lighting provides excellent visibility of cooking areas, making it easier to monitor progress without opening the oven door.

In terms of safety, the Precision Series is equipped with features such as automatic reignition and heavy-duty knobs, ensuring that cooking is not only efficient but safe as well.

With its blend of technology, power, and style, the Capital Cooking Precision Series proves to be an exceptional choice for those who prioritize quality and performance in their culinary adventures.
Top Page Image Contents