Capital Cooking Precision Series S T Install C H E C K, Final Checklist, Electrical, Operation

NOTE: NO air shutter adjustment is necessary or possible with the sealed top burners.

NOTE: If the sealed burners do not ignite and there is NO clicking sound, turn OFF the gas and check for tripped circuit breakers, blown fuse or wire connection to the igniter.

INSTALLER CHECKLIST

FINAL CHECKLIST

qPlacement of unit

qSpecified clearances maintained to cabinet surfaces

qUnit Level – front to back – side to side

qBurner caps positioned properly on sealed burner bases

qAll packing materials removed

qIsland trim or back guard attached (if horizontal clearance to combustible materials behind cooking surface is less than 12”)

qCheck door adjustment and hold down brackets

GAS SUPPLY

qConnection: 1/2” NPT with a minimum of 5/8” diameter flex line

qThe appliance is connected only to the type of gas for which it is certified for use

qManual gas shut-off valve installed in an accessible location (without requiring removal of range)

qUnit tested and free of gas leaks

qGas supply pressure does not exceed 14” (37 mb) W.C.

P O S T - I N S T A L L C H E C K

ELECTRICAL

qReceptacle with correct over current protection is provided for service cord connection

qProper ground connection

qProper polarity at receptacle

qKick panel in place and 3 screws secure.

OPERATION

qAll internal packing materials removed. Check below grates and grill pans and within ovens

qIf used on Propane gas, verify that the propane gas supply is equipped with its own high-pressure regulator in addition to the pressure regulator supplied with appliance.

qBurner caps properly seated into burner bases.

qGrill Components properly seated (not all models).

qBezels centered on burner knobs and knobs turn freely.

qEach burner lights satisfactorily, both individually and with other burners operating

qAir shutter adjustment for proper flame made for Grill and Griddle sections.

qGriddle is level and does not rock.

qOven door hinges seated and hinge locks in proper position. Door opens and closes properly.

qBurner grates correctly positioned, level and do not rock.

Note to Customer:

Please make sure installer signs each item on this checklist, explains each item before leaving.

37