American Standard 3841.000 Install Handles, Test Installed Fitting, Check Drain Connections

10 INSTALL HANDLES

See separate installation instructions supplied with handle kits for installing handles onto fitting.

11 TEST INSTALLED FITTING

With HANDLES (1) in OFF position, turn on WATER

SUPPLIES (2) and check all connections for leaks.

Remove AERATOR (3).	5
	1
Operate both HANDLES (1) to flush water
lines thoroughly.
Replace AERATOR (3).	1

3

12 CHECK DRAIN CONNECTIONS		4
Operate POP-UP KNOB (5) and fill Sink with water. Check
that DRAIN STOPPER (4) makes a good seal and retains
water in Sink. If STOPPER (4) does not seal properly, please		WASTE
refer to “Troubleshooting Guide” in these instructions.
		OUTLET
Release POP-UP KNOB (5) down and check all drain		2
connections and "P" trap for leaks. Tighten		COLD
if necessary.	HOT
TO CLEAN AERATOR		“P” TRAP
AERATOR (3) may accumulate dirt causing distorted
		2
and reduced water flow. Unscrew and remove
AERATOR (3) and rinse clean.

Replace AERATOR (3) and operate handles several times from OFF to ON position. Do not force, handles turn only 90˚.

13 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

14 SERVICE	HANDLE
	ASSEMBLY

To change direction of handle rotation, proceed as follows:

Turn valve to OFF position. See handle instructions with handle kit for removing handles.

Remove ADAPTER SCREW (1) and pull of ADAPTER (2).

Remove SPRING CLIP (3). Lift STOP WASHER (4), turn 90° and replace. Replace SPRING CLIP (3).

Replace handle assembly. See handle instructions	4	90˚
with handle kit for installing handles.

1

2

3

43167 Rev. 1 . 3

4