4 TEST INSTALLED FAUCET
Move HANDLE (1) down into "off" position.
Turn on water supplies and check all connections for leaks.
1
3 5
2
4
With HANDLE (1) down in "off" position.
Pull HAND SPRAY (2) from FAUCET (5) and disconnect HAND SPRAY (2). Pull HOSE (3) (HOSE should pull approximately 2 feet) and direct open HOSE END (4) into sink.
Operate handle up and down, in COLD and HOT positions, to flush water lines thoroughly.
Connect HAND SPRAY (2) to HOSE END (4). Place HAND SPRAY (2) back into faucet, operate HANDLE (1) and check all connections for leaks.
Check HAND SPRAY (2) operation:
With faucet on push front of BUTTON for a broad cleansing spray.
CHECK CONNECTIONS
FOR LEAKS
5 SERVICE
3
Reduced flow. If the flow should gradually be reduced over a number of months, | 2 |
the AERATOR may have debris in it. To clean, remove AERATOR (1) and rinse with |
|
water to remove any debris. Turn on faucet to wash any debris out of the faucet. Screw AERATOR (1) back to the spout. Operate faucet.
Clogged CARTRIDGE outlets or inlets may cause reduced flow.
To clean, first turn off water supply then:
Remove BUTTON (2) and loosen HANDLE SCREW (2) and pull off HANDLE (3).
Remove ESCUTCHEON CAP (4) by pulling it upward. Unscrew the three CARTRIDGE SCREWS (5) and remove CARTRIDGE (6).
Clean inlets of CARTRIDGE (6) and MANIFOLD (7).
Reassemble CARTRIDGE (6), alternately tightening SCREWS (5). Replace CAP (4) and HANDLE (3), check flow.
4
5
6
7
1
6 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
