Installation
Instructions
QUINCE™4433.001
SINGLE CONTROL KITCHEN
FAUCET WITH CAST SPOUT
Thank you for selecting
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds
Certified to comply with ANSI A112.18.1M
M 9 6 5 115 _ Rev. 1. 1
Recommended tools
Regular Screwdriver | Phillips Screwdriver | Adjustable Wrench | Plumbers' Putty or Caulking |
|
|
|
1 INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON CAUTION
Make certain the SEAL (9) is properly seated in recess of spout base.
Turn off hot and cold water supplies before beginning.
(A)Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON with PUTTY PLATE (1). Insert supply HOSES (2) and SHANK (3) through hole of ESCUTCHEON with PUTTY PLATE (1) and mounting surface. Follow mounting instructions below to secure faucet to mounting surface.
(B)Installation less ESCUTCHEON (1). Insert all HOSES (2) and SHANK (3) through MOUNTING RING (10) and mounting surface. Do not use putty.
Assemble RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6) onto SHANK (3) from underside of sink or mounting surface. Hand tighten LOCKNUT (6) and check that rotation of HANDLE (7) from HOT to COLD is centered.
Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening the screws slightly each time until all are snug to ensure even pressure.
7
A 
B
9
1 | 10 |
7
9 
| 3 |
PUTTY | 2 |
| 2 |
3
4
5
8
6
SINK OR
MOUNTING
SURFACE
4
5
8 | 6 |
|
