
5 SERVICE
Reduced flow. If the flow gradually reduces over a number of months, the AERATOR (12) may have collected debris. To clean, remove AERATOR (12) and rinse with water and remove any debris. Turn on faucet to wash any debris out of the faucet. Thread AERATOR (12) back into spout. Operate faucet.
Spout leakage. If fitting leaks above or below SPOUT HUB remove SPOUT as follows and check SPOUT
Remove HANDLE BUTTON (2) and loosen SET SCREW (1) with 2.5mm HEX |
| 3 | |
WRENCH (11) supplied. Pull HANDLE (3) off valve stem. | 1 | ||
| |||
Pull off CAP (4). Loosen CARTRIDGE SCREWS (5) and remove CARTRIDGE (6). | 2 |
| |
|
| ||
Remove SPOUT (7) by pulling up gently while moving SPOUT (7) side to side. | 11 |
| |
Check both SPOUT | 4 | ||
|
| ||
On models with SPRAYS, DIVERTER (9) can be cleaned by pulling |
|
| |
DIVERTER (9) out of the MANIFOLD (10). Rinse clean the DIVERTER (9) |
|
| |
and MANIFOLD (10). Push DIVERTER (9) back into MANIFOLD (10). |
| 5 | |
Reverse procedure to reinstall SPOUT, CARTRIDGE and HANDLE. |
| 6 | |
Clogged CARTRIDGE outlets or inlets may cause reduced flow. |
| ||
|
| ||
To clean, first turn off water supply then: |
| 13 |
Remove PLUG BUTTON (2), loosen HANDLE SCREW (1) and remove HANDLE (3).
Remove ESCUTCHEON CAP (4). Unscrew the three CARTRIDGE SCREWS (5). Clean MANIFOLD (10), CARTRIDGE (6) ports and SEALS (13).
Clean inlets of CARTRIDGE (6) and MANIFOLD (10).
Reassemble CARTRIDGE (6), alternately tightening SCREWS (5). Replace CAP (4) and HANDLE (3). Check flow.
7
12
10
8
SPOUT
HUB
9
6 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.