| Installation |
ELITE | Instructions |
4453 SERIES | |
SINGLE CONTROL KITCHEN FAUCET | 4454 SERIES |
and HAND SPRAY |
|
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds
Certified to comply with ANSI A112.18.1M
M968202 REV . 1 . 2
TOOLS REQUIRED
Phillips Screwdriver
Channel Locks | Adjustable Wrench | Plumbers' Putty or Caulking | Regular Screwdriver |
CARE:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
1 | INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON | ||
|
| Turn off hot and cold water | |
| CAUTION | ||
|
|
| supplies before beginning. |
|
|
|
(A) Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON WITH PUTTY PLATE (1). Insert supply HOSES (3) and SHANK (4) through hole of ESCUTCHEON WITH PUTTY PLATE (1) and mounting surface. Make certain the SQUARE SEAL RING (2) is properly seated in recess of SPOUT BASE. Follow mounting instructions below to secure faucet to mounting surface.
(B) Installation less ESCUTCHEON (1). Remove ESCUTCHEON WITH PUTTY PLATE (1) and Insert supply HOSES (3) and SHANK (4) through mounting hole and seat SPOUT BASE onto sink or mounting surface. Make certain the SQUARE SEAL RING (2) is properly seated in recess of SPOUT BASE. Do not use putty.
Assemble RUBBER WASHER (5), BRASS WASHER (6), and threaded LOCKNUT (7) onto SHANK (4) from underside of sink or mounting surface. Hand tighten LOCKNUT (7) and check that rotation of HANDLE (8) from HOT to COLD is centered.
Use a screwdriver to tighten SCREWS (9) on LOCKNUT (7). Work your way around LOCKNUT (7), tightening the screws slightly each time until all are snug to ensure even pressure.
A |
| B | 8 |
|
| ||
8 |
|
|
|
SPOUT BASE | SPOUT BASE |
|
|
2 | SQUARE |
| SQUARE |
SEAL RING |
| ||
|
|
| SEAL RING |
1 | 2 | |
| 4 | |
P U T T Y | 3 | |
3 | ||
|
4
6
9 7
SINK OR
MOUNTING
SURFACE
5
6
9 7