American Standard 6028.240 installation instructions Speed Connect Drain, 7 8 4, Dazzle, Fig. A

	Installation
DAZZLE	Instructions
Mini Spread Lavatory Faucet with	6028.240

Speed Connect Drain*

Congratulations on purchasing your American Standard faucet with Speed Connect drain, a feature found only on American Standard faucets.

Speed Connect Drain*

•1/3 of the parts, installs in 1/3 of the time

•No tools needed

•Never needs adjustment

•Guaranteed to seal properly the first time, every time.

Certified to comply with ANSI A112.18.1

M968491 Rev . 1 . 2

*Your new American Standard faucet is designed to work only with the Speed Connect drain. Helpful tips for removing your current drain can be found in the Troubleshooting section of these instructions.

To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.

Recommended tools

Screwdriver Channel Locks Adjustable Wrench Tubing Cutter

1			Turn off hot and cold water
	INSTALL FAUCET	CAUTION
			supplies before beginning.

Insert SPOUT (1) through center hole of mounting surface, making sure the SPOUT ESCUTCHEON (2) and SEAL WASHER (3) are properly seated.

Assemble RUBBER WASHER (4), BRASS WASHER (5) and LOCKNUT (6) onto SPOUT SHANK (7) from under side of sink . Make sure SPOUT (1) is centered in the sink hole, the slot in the BRASS WASHER (5) is in back and the O-RING (8) is seated at the end of SHANK (7).

Tighten LOCKNUT (6) on SPOUT (1) firmly. Fig. A.

SINK OR

MOUNTING

SURFACE

1a INSTALL VALVE BODY

Install the valve LOCKNUT (1), FRICTION WASHER (2) and RUBBER WASHER (3) onto the two VALVE SHANKS (4) if not already installed. The LABEL indicating the front of the fitting faces the front of the sink.

Fig. A.

1

2

3

SLOT

7

8

4

5

6

Insert VALVE BODY (5) through holes from under side of SINK. Threads of both VALVE SHANKS (4) should extent at least 5/16 inch above SINK top. Fig. B. Be sure SHANK (9) and O-RING (6) of SPOUT (7) is pushed into TEE (8) section of the VALVE BODY (5). Fig. C.

Install ESCUTCHEONS (10) with RUBBER RINGS (11) and screw ESCUTCHEONS (10) onto VALVE SHANKS (4) until snug against internal stop. Adjust LOCKNUTS (1) downward if necessary.

Tighten LOCKNUTS (1) on VALVE SHANKS (4) firmly to secure fitting.

Drop LIFT ROD (12) through hole in SPOUT (7) and thread ROD END (13) into the TAB (14) in the VALVE BODY (5). Fig. C.

10 Fig. B.

11

5/16'' MIN.

SINK

WRENCH

Fig. C. 12

10

11

SINK
4	13
3	14		8
2
	FRO	NT	FRONT
1

7

9

6

5

POP-UP

CABLE

1