5 CONNECT FLEXIBLE HOSE TO DIVERTER
Thread the HOSE COUPLING (1) onto DIVERTER NIPPLE (2) and hand tighten clockwise. Note: Moulded end of HOSE COUPLING (1) creates watertight seal with with thread of DIVERTER NIPPLE (2), so seal washer is not required.
Make sure HOSE (3) is not kinked or twisted.
2
1
3
6 OPERATION
SPRAY UNIT (1) can be adjusted up and down by sliding unit along the rails. (See Maintenance section for steps to adjust the tension of SPRAY UNIT (1) on the rails.)
Shower function can be diverted by rotating DIVERTER ARM (2) clockwise for flow out of SPRAYS (3) and counter- clockwise for flow out of
SHOWER HEAD (4).
SHOWER HEAD SPRAY (5) can be adjusted by rotating outer ring on the faceplate.
2
5 
4 
UP AND DOWN TRAVEL OF UNIT 
1 3
7 MAINTENANCE | Figure 3 |
Removing spray for cleaning or changing spray location |
|
Figure 1. Unscrew the TRIM RING (2) on the outside of the SPRAY HEADS (1) |
|
by twisting 1/8th of a turn |
|
Remove the |
|
Nozzle (3) can be cleaned using soft bristled brush. | 7 |
Replace |
|
twisting it clockwise until it clicks. |
|
GROOVE
5
6
TAB
2 | 4 | 3 | 1 |
5
TO REMOVECLOCKWISE
TO INSTALL
Figure 1
6
Adjusting tension of SPRAY UNIT on vertical rails.
Shower system comes with two FRICTION CLIPS (5) installed.
Move SPRAY UNIT (6) up and down along vertical rails. FRICTION CLIP (5) holds the SPRAY UNIT (6) at desired location.
(Figure 2) If SPRAY UNIT (6) has too much tension on vertical rails, then remove one FRICTION CLIP (5) or reposition the CLIPS (5) closer to the center of the unit. (Note: Tension on vertical rails will reduce when 5 shower system is moistened from shower application.)
(Figure 3) To replace FRICTION CLIP (5), insert |
|
groove of FRICTION CLIP (5) onto inside edge of |
|
SPRAY UNIT (6). Rotate other end down and press |
|
until the FRICTION CLIP (5) snaps into position onto |
|
tab of SPRAY BODY (7). | Figure 2 |
VERTICAL RAILS
8 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH
SOAPS, ACID, POLISH, ABRASIVES,
HARSH CLEANERS, OR A CLOTH
WITH A COARSE SURFACE.
HOT LINE FOR HELP
For
1 (800)
Weekdays 8:00 a.m. to 7:00 p.m. Eastern Time
IN CANADA
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A m e r i c a n S t a n d a r d I n c . © A m e r i c a n S t a n d a r d I n c . 2 0 0 4
M 9 6 8 4 1 6 R E V 1 . 1
