WIRE SELECTION GUIDE |
|
|
|
| |
|
|
|
|
| |
| Maximum distance from | ||||
|
| fusebox to motor |
| ||
Motor |
|
|
|
|
|
50' | 100' | 150' |
| 200' | |
Hi Performance |
|
|
|
|
|
Rating |
| 115V Power Line |
| ||
2.1 |
|
| |||
|
|
|
|
| |
| 12 | 10 | 8 |
| 8 |
|
|
|
|
|
|
The sizes shown on this
chart are recommendations
for copper conductors
only. Always follow
local and national
electrical codes
DRAIN CONNECTION AND SYSTEM TEST
Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the pump couplings and make sure they are
E-Z INSTALL WHIRLPOOL HEATER OPERATION
WARNING: Prior to operation, review the Important Safety Instructions listed in this instruction manual.
Once the heater is installed and the whirlpool pump is operating, the heater is totally automatic. The heater will help maintain the temperature of the water in the bath.
Pressure Switch
The heater is equipped with a preset pressure switch. The pump must be running with water flowing in the whirlpool to allow the heater to turn on.
Indicator Light
This light turns on whenever the heater is operating. See Fig. 2.
The heater includes an exclusive "Intelligent
OVERHEAT
PROTECTION
HEATER ON
RESET
Fig. 2
E-Z INSTALL
WHIRLPOOL HEATER
POST INSTALLATION
Remove all construction debris from bath. Tile grout can be removed with a wooden popsicle stick or tongue depressor. Do not use wire brushes or any other metal implement on bath surface.
Post installation
Painter's naphtha can be used to remove excess adhesives and/or wet
HARSH CHEMICALS SHOULD NEVER BE USED ON ACRYLIC SURFACES.
Abrasive cleaners must not be used since they will scratch and dull the surface. Dulled areas can be restored by rubbing with a white
(5) | SPIC AND SPAN | ® | IS A REGISTERED TRADEMARK OF PROCTER & GAMBLE | |
|
|