American Standard 7010.901 installation instructions Installation Instructions, Green Tea

Installation

Instructions

GREEN TEA	7010.900
DECK-MOUNT BATH FILLER	7010.901

Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years.

To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin.

Certified to comply with ANSI A112.18.1M

M968595 Rev . 1 . 2

Recommended Tools ROUGHING-IN DIMENSIONS

Flat Blade Screwdriver

10-5/8"

ADJ. 6-1/2 TO 12

*Wrench

Adjustable Wrench

Channel Locks

*Hex key *Supplied with Fitting

MOUNTING

SURFACE

2-9/16"

8-1/16"

5-5/16"2-1/8"

3-3/4" 3"

1-1/8 DIA.

3/4-14 MALE	(H)
N.P.T. INLETS
1-1/16 DIA.

7-7/8"

(200mm)

	2-1/16"	2-1/16
		DIA.
	DIA.
1-1/4		1-1/2 MAX.
MAX.
	3

1-3/16 DIA. (C)

12 MAX

1 SPOUT ASSEMBLY

CAUTION	Turn off hot and cold water
	supplies before beginning.

Install RING WASHER (1) into SPOUT recess. Check that O-RING (2) on end of SPOUT SHANK (3) is in place. Insert SPOUT SHANK (3) through center hole on mounting surface.

Assemble RUBBER WASHER (4) and BRASS WASHER (5) and LOCKNUT (6) onto SPOUT SHANK (3). Align SPOUT ASSEMBLY and from underside of ledge secure SPOUT ASSEMBLY into position with LOCKNUT (6).

SPOUT

ASSEMBLY

SPOUT RECESS

1

3 2

MOUNTING

SURFACE

4

5

6

2 PREPARE TUBE AND TEE ASSEMBLY

Prepare TUBE and TEE ASSEMBLY (1) to fit center to center VALVE (2) location (between 6-1/2" and 12"). If necessary, cut and/or bend TUBING carefully. Make sure tube bend is close to the TEE (1) so that it will not effect the compression joint at the VALVE CONNECTION.

Remove COUPLING NUT (3) and FERRULE (4) from each VALVE (2) and slide onto TUBING (5).

4

3

1

5

3

4

ADJ. 6-1/2 TO 12

MOUNTING

SURFACE

2

NOTE VALVE inlet is 3/4-inch NPT male.