3 VALVE ASSEMBLY
Install LOCKNUTS (1) and RUBBER WASHERS (2) onto valve shanks.
Push TUBING (3) ends into VALVE (4) side outlets. Insert VALVES (4) into mounting holes from underside of ledge.
Press TEE (5) onto SPOUT SHANK (6) making certain that the
Thread of VALVE BODY (4) should extend at least 5/16 inch above MOUNTING SURFACE (11). If necessary, adjust LOCKNUT (1).
Place RUBBER RING (10) into ESCUTCHEON ADAPTERS (9) and thread onto valves until snug against internal stop.
Tighten LOCKNUT (1) to secure VALVE (4) position.
9
10
HOT
12
11
9
10
7
13 6
MOUNTING
SURFACE
Slide FERRULE (12) and COUPLING NUT (13) to outlet of VALVE (4) and tighten |
|
| |||
COUPLING NUT (13) firmly. |
|
|
| 4 |
|
Connect HOT water supply to inlet of left VALVE and COLD water supply to inlet of |
| ||||
3 |
| ||||
right VALVE using appropriate connector. |
|
| 5 | ||
8 |
|
| |||
|
|
|
|
| |
5/16'' MIN. |
| 7 | 8a |
| 8 |
4 | 11 | MOUNTING |
|
| |
|
|
| |||
SURFACE
12
13
COLD
2
1
4 INSTALL HANDLES
FOR FITTING LESS SPRAY
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without a spline is facing up. Fig. A. Tighten
STEM SCREW (3) to secure ADAPTER (1).
Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting | 4a | |
male teeth on ADAPTER (1) to female teeth in HANDLE (4). Push | TOP | |
LEVER HANDLE ASSEMBLY (4) down onto ADAPTER (1). | ||
| ||
Thread base of LEVER HANDLE ASSEMBLY (4a) onto DECK |
| |
ADAPTER (5) until snug against mounting surface. | Fig. A. | |
|
4
1
3
2
SPLINE END DOWN
5 | SERVICE |
| ||
To change direction of handle: |
| |||
|
|
| Turn valve to OFF position |
|
|
|
|
| |
|
|
|
| |
|
|
| Thread HANDLE BASE (1a) counter |
|
|
|
|
| |
|
|
|
| |
|
|
| Pull HANDLE (1) “UP” firmly to release from ADAPTER (2). | 1a |
|
|
| ||
|
|
| ||
|
|
| Remove SPRING CLIP (3). Lift STOP WASHER (4), turn 90˚ | |
|
|
| ||
|
|
| ||
|
|
| and replace. Replace SPRING CLIP (3). |
|
rem
o
ve
|
| l |
|
| l |
| a | |
t |
| |
ins |
|
|
5
1
If spout drips, operate handles several times from OFF to ON position.
Do not force - handles turn only 90˚.90˚ 2
4
3
2
M968595 Rev . 1 . 2
