American Standard 7236EC dimensions General Specifications for 7236E Whirlpool

VIRTUOSO ELITE™

WHIRLPOOLS BY AMERICAN STANDARD

HIGH GLOSS ACRYLIC

				1829mm
			914mm	(72)	19mm
			(36)
					(3/4)
CUTOUT	X 876mm	X 34-1/2)			TYP.
			914mm
OUTLINE OF	1791mm	(70-1/2	(36)
				PUMP
				178mm X 356mm	PROVIDE ACCESS	TOPUMP FOR SERVICE ON ALL INSTALLATIONS
				(7 x 14) CUTOUT
			C/L OF	102mm
			DRAIN	(4)	470mm
			279mm		(18-1/2)
			(11)	RECOMMENDED	ON/ OFF
					SWITCH
				FITTING LOCATION
				64 X 279mm (2-1/2 X 11)
			C/L OF	IN-LINE HEATER
			OVERFLOW		51mm
				REMOVABLE BLANK
					(2)
			76mm
			(3)
					489mm
					(19-1/4)

44mm (1-3/4)

89mm (3-1/2)

	LEVELING	540mm
	STRINGER
	NOT FOR	21-1/4
	SUPPORT
	ROUGH FLOOR
1-1/2 N.P.T. THREAD	INTEGRAL
	FEET
1-1/2 O.D.
TAILPIECE

GENERAL SPECIFICATIONS FOR 7236E WHIRLPOOL

INSTALLED SIZE	72 x 36 x 21-1/4 In. (1829 x 914 x 540mm)
WEIGHT		101 Lbs. (45 Kg.)
WEIGHT w/WATER		751 Lbs. (338 Kg.)
GAL. TO OVERFLOW		78 Gal. (296 L)
WHIRLPOOL MIN. OPERATING VOL.		69 Gal. (262 L)
BATHING WELL AT SUMP		46 x 18 In. (1168 x 457mm)
BATHING WELL AT RIM		66 x 30-1/2 In. (1676 x 775mm)
WATER DEPTH TO OVERFLOW		15-3/4 In.(400mm)
FLOOR LOADING		42 Lbs./Sq.Ft. (204 Kgs./Sq.m)
(PROJECTED AREA)
PTS.		25.6
CUBE (FT3)		49.4
WHIRLPOOL ELECTRICAL SPECIFICATIONS
PUMP		2.1 HP,14.4 AMPS,120V.

NOTES: BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND OR PENINSULA TYPE INSTALLATION. SUMP OF BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIAL BY OTHERS.

■REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL, DECK MOUNTED SPOUT AND INTEGRATED BATH FILLER FOR ADDITIONAL INFORMATION.

OPTIONAL 3-WALL TILING BEAD KIT No. TILE-BEAD AND APRON No. 6FT-APRON MUST BE ORDERED SEPARATELY.

PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.

●IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING SYSTEM PIPING, DRAIN OVERFLOW, AND APRON INSTALLATION. MOUNTING HOLES DRILLED BY INSTALLER.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1

These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaflet.

© 2003 American Standard Inc.