™
Installation
Instructions
LAKELAND™ UNDERCABINET STORAGE RACK
8193.140
Thank you for selecting
BEFORE YOU BEGIN:
•Carefully unpack your accessory, check the contents, and inspect carefully for damage.
•Mounting Kit Consists Of:
•4 Clips
•2 Long and 2 Short Metric Machine Screws
•10 Flat and 4
RECOMMENDED TOOLS & MATERIALS:
• Phillips Screwdriver | • Pliers |
• Regular Screwdriver (Small) | • Tape Measure |
• Masking Tape or Yellow Crayon | • Flash Light |
Note: The top of the rack is manufactured with a slope. When it is correctly installed under the sink the bottom of the rack will be parallel with the rim of the sink.
IMPORTANT: DIMENSION OF FIXTURES ARE NOMINAL AND MAY VARY WITHIN PERMITTED MANUFACTURING TOLERANCES.
1 • Locate the fixing screw holes on the underside of the sink.
• Make sure the threads are clear and mark around them. Fig 1.
Fig.1
Fixing Screw
Hole Locations
2 • Put two clips on each of the top thick wires.
•Gently squeeze them closed.
•The exact location of the clips may vary depending on whether you want to position your storage rack to the left or right. Fig 2 & 3.
Fig.2 | Fig.3 |
|
© A M E R I C A N S T A N D A R D I N C . 2 0 0 5 | 7 9 1 4 0 7 - 1 0 0 |