American Standard 8871 POP-UP Drain, Remove Flange, Drain Outlet, Flange Gasket and POP-UP Knob

2 POP-UP DRAIN

Remove CLEAR PLASTIC COVER (1).

Remove CARDBOARD SPACER (2) from under DRAIN POP-UP (3).

Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY. Fig. B.

Fig. A.

1

3

2

Fig. B.

DRAIN

BODY

4

3 REMOVE FLANGE

Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain body. Fig. A.

Thread LOCKNUT (3) clock-wise to bottom of drain body. Push GASKET (4) down against LOCKNUT (3). Fig. B.

Fig. A.

1

2

Fig. B.

4

3

4	INSTALL DRAIN FROM	REAR OF SINK	5 TIGHTEN LOCKNUT
	BELOW FIXTURE
	From under side of SINK	4	Tighten LOCKNUT (1) firmly with Adjustable
	install DRAIN BODY (1) up		Wrench or Channel Locks.
	through drain outlet.
	Note: No plumber’s putty	DRAIN
		OUTLET
	or caulk is required.	3
	The CABLE ATTACHMENT
	POINT (2) must face towards
	the rear of the SINK.	1	1
	Install FOAM GASKET (3) and
		2
	FLANGE (4) onto drain body
	from above SINK and tighten
	FLANGE (4) firmly.

6 FLANGE GASKET AND POP-UP KNOB	Fig. A.	Fig. B.	DOWN
Check DRAIN FLANGE in SINK to ensure that			1
WHITE FOAM GASKET (3) is fully compressed
and not visible. Fig. A.
POP-UP KNOB (1) must be fully down. Fig. B.	WHITE FOAM
	GASKET	DRAIN
	NOT VISIBLE	FLANGE
			M966230 Rev. 1.2
	2