American Standard 8871 installation instructions Fig. A

7	ATTACH CABLE CONNECTOR
		Fig. A.		Fig. B.
	Thread CABLE CONNECTOR (1) clockwise
	onto DRAIN BODY CONNECTION (2) and		1
	hand tighten. Fig. A.

Your new POP-UP DRAIN installation is now complete. Fig. B.

Note: Tailpeice on pop-up drain is 1-1/4” O.D.

Fig. B.

2

1-1/4” O.D.

8	CHECK OPERATION OF POP-UP
		1
	Operate LIFT KNOB (1) to verify that STOPPER (2) opens and
	closes.

Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions.

2

9 MAKE WATER SUPPLY AND WASTE CONNECTIONS

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS NOT INCLUDED

AND MUST BE PURCHASED SEPARATELY.

Thread TEE BODY (4) to SPOUT SHANK (5).

Thread HOSE CONNECTOR (6, 6A) to VALVE CONNECTIONS (7, 7A).

Connect water supply to VALVE BODIES (1,1A) with 1/2" IPS FLEXIBLE
SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3). Use
adjustable wrench to tighten connections. Do not over tighten.
Be careful not to kink copper supply when bending. Use tubing				1A
cutter to cut to proper length.
Connect HOT water supply to inlet of left SHANK and COLD			5	7A
				6A
water supply to right SHANK using sealant, appropriate
connectors, and COUPLING NUTS.				COUPLING
Connect 1-1/4” O.D. tailpiece on POP-UP DRAIN to				NUT
	1
waste outlet.		7	4
				3
1/2" PIPE THREAD		6
			3/8 O.D.
			BULL-NOSE	COMPRESSION
	2		RISERS
				NUT
		FLEXIBLE
			COLD	FERRULE
		SUPPLIES
HOT		3/8 COMPRESSION
		CONNECTION

M966230 Rev. 1.2

3