4 |
|
SEALANT | WAX RING |
|
INSTALL WAX SEAL
5
FLANGE
NUT
TAPERED
WASHER
CLOSET
BOLT
Invert toilet on floor (cushion to prevent damage), and install wax ring evenly around waste flange (horn), with tapered end of ring facing toilet. Apply a thin bead of sealant around base flange.
POSITION TOILET ON FLANGE
a.Unplug floor waste opening and install toilet on closet flange so bolts project through mounting holes.
b.Loosely install retainer washers and nuts. Side of washers marked "THIS SIDE UP" must face up!
6
BOLT CAP
CLOSET FLANGE
CLOSET BOLT
WASHER NUT
INSTALL TOILET
a.Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor.
!CAUTION:
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b.Install caps on washers. (If necessary, cut bolt height to size before installing caps.)
c.Smooth off the bead of sealant around base. Remove excess sealant.
7a | For Tanks/Bowls using Speed |
| Connect System (Tank |
mounting bolts
TANK MTG. | RUBBER | |
GASKET | ||
BOLTS PRE- | ||
| ||
INSTALLED |
|
WASHER
NUT
INSTALL TANK
a.Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening, and tank mounting bolts go through mounting holes. Secure with metal washers and nuts.
b.With tank parallel to wall, alternately tighten nuts until tank is snugged down evenly against bowl surface.
!CAUTION:
DO NOT OVERTIGHTEN NUTS MORE THAN REQUIRED FOR A SNUG FIT!
7b For all other Tanks/Bowls
RUBBER
WASHER
RUBBER
TANK MTG. GASKET BOLTS
WASHER
NUT
INSTALL TANK
a.Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening.
b.Insert tank mounting bolts and rubber washers from inside tank, through mounting holes, and secure with metal washers and nuts.
c.With tank parallel to wall, alternately tighten nuts until tank is snugged down evenly against bowl surface.
!CAUTION:
DO NOT OVERTIGHTEN NUTS MORE THAN REQUIRED FOR A SNUG FIT!
8 | INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions. |
|
- 2 - | 730237 - 100 REV . Q |