User Programming Mode
To enhance the flexibility of the Gardtec 350 control panel there are five user programmable options available. When programming the user options the display is via the five zone LEDs and the legend to the right of the LEDs is used (see illustration below). It should be noted that User Programming Mode is only available to Master level codes ( User Numbers 1, 4 and 5 please refer to user code programming for more details).
Bold legend for normal use
User programming mode legend
System Status LEDs
LED Modes
When programming the user options three LED states are possible.
User Programmable Options
Five User Programmable options are available, these are.
REMOVE
This option enables a Master user to Remove (turn off) individual zones when setting the system. This is in addition to any part sets that may have been programmed by the installation engineer. When this option is used it should be noted that the selected zones will be removed for the one set only.
