Ampeg SVT-5 PRO manual Connections, Mono Bridged

SVT-5 PRO Bass Amplifier

Connections

MONO BRIDGED: The SVT-5 PRO’s two internal amplifiers are bridged together to produce maximum output power.

•Full Range/Biamp switch out (full range), Stereo/Mono switch depressed (mono)

• Connect a heavy duty speaker cable ( ) from the SVT-5 PRO’s Mono Bridge/Biamp Speakon® jack to the input of a full range speaker cabinet

• Speakon® pin 1 + = signal “+,” pin 2+ = signal “–”

Mono

Bridged

SVT-5 PRO

MONO

BRIDGE

1

OUT (FULL

RANGE)

IN

(MONO)

TO

INPUT

JACK

FULL RANGE CABINET(S)

NOTE: BE

ABSOLUTELY CERTAIN THAT THE CABINET(S) ARE ABLE TO HANDLE THE EXTREMELY HIGH OUTPUT POWER OF THE AMP IN THIS MODE!

DUAL MONO: The SVT-5 PRO’s two internal amplifiers will each power a full range cabinet.

•Full Range/Biamp switch out (full range), Stereo/Mono switch out (stereo)

• Connect a heavy duty speaker cable (	) from the SVT-5 PRO’s Power Amp A jack to the input of a full range speaker cabinet
• Connect a heavy duty speaker cable (	) from the SVT-5 PRO’s Power Amp A jack to the input of a full range speaker cabinet

Dual

Mono

SVT-5 PRO

PWR	PWR
AMP B	AMP A
2	1
	OUT (FULL
	RANGE)	TO
	OUT	INPUT
	(STEREO)	JACK
		TO
		INPUT
		JACK

FULL RANGE CABINET(S)

FULL RANGE CABINET(S)

BIAMP - Full Range / Lows: One of the SVT-5 PRO’s internal amplifiers will power a full range cabinet, the other will power a low frequency cabinet.

•Full Range/Biamp switch out (full range), Stereo/Mono switch out (stereo)

• Connect a signal cable ( ) from the SVT-5 PRO’s Biamp Low Output jack to its Amp A Power Amp Input jack

• Connect a heavy duty speaker cable (	) from the SVT-5 PRO’s Power Amp A jack to the input of a full range speaker cabinet
• Connect a heavy duty speaker cable (	) from the SVT-5 PRO’s Power Amp A jack to the input of a full range speaker cabinet

SVT-5 PRO	BIAMP
Biamp - Full	LO OUT
	PWR	PWR
Range / Lows	AMP B	AMP A		PWR
	3	2
				AMP A
				AMP
		OUT		INPUT
			(FULL	1
		OUT	RANGE)
		(STEREO)

Use the Crossover Frequency control (#28) to set the crossover point for the low output.

6

TO

INPUT

JACK

TO

INPUT

JACK

FULL RANGE CABINET(S)

LOW FREQ. CABINET(S)