Ampex Data Systems ATM 300 manual Unpacking and Inspection, Rack Mounting, Data Connections

Unpacking and Inspection				ATM 300 Series
		Table 1. Specifications (Continued)
	Parameter			Specification
	Optical Data Cables		62.5/125 µm multimode fiber (ATM 300 and ATM 300M)
			8.3/125 µm singlemode fiber (ATM 300S)
	Electrical Data Cables		Ampex provides the following accessory cable kits:
			Ampex Part No.	Size
			1308564-01	120-in (305 cm) - standard
			1308565-01	180-in (457 cm)
			1308566-01	300-in (762 cm)
			1308567-01	600-in (1524 cm)
	SyncStart Connector		BNC
	Power Requirements		100-240 Vac, 47-63 Hz single phase, 150 watt maximum
	Dimensions		19” (480 mm) rack mountable
			17.0” W x 1.875” H x 8.0” D (432 mm x 48 mm x 203 mm)

1.2Unpacking and Inspection

Perform the following inspection upon receipt of the unit:

1.Unpack and check the unit for shipping damage. If equipment is damaged notify the carrier immediately.

2.Check equipment received against the packing list to ensure that the shipment is complete. If any shortages exist, promptly contact the sales representative.

1.3Rack Mounting

Ampex ships the ATM as a desk top unit. However, the unit can be mounted into a standard 19-inch (284 mm) rack using the hardware provided. To mount the unit into a rack, install the two brackets on either side of the unit using the four machine screws provided. Then, mount the completed assembly to the rack rails.

1.4Data Connections

The ATM unit provides fiber optic connectors on the front panel and HOTLink connectors on the rear panel. Figure 2 shows the cable connections. See Table 1 for cable specifications.

2 Ampex 1308903-02