Amphony 1000 Installing the headphone batteries, Push, Lift, User and Installation Guide, Page

Models: 1000

1 8
Download 8 pages 1.29 Kb
Page 4
Image 4
￿￿￿￿￿￿ Installing the headphone batteries

User and Installation Guide

￿￿￿￿￿￿ Installing the headphone batteries

R

Two AA (UM-3, R6, Mignon - 1.5 V) batteries are required to operate the headphones. Rechargable batteries with a sufficiently high voltage can be used as well. Choosing batteries with a high capacity (mAh) will extend operating time.

There are two battery compartments, located on both sides, each housing one battery. To access each battery compartment, push on the outer edge of the battery lid. This will release the battery lid. Then lift the middle portion of the battery lid to gain access to the battery compartment.

Insert the battery by pressing the minus pole of the battery against the spring at the bottom of the battery compartment until the plus pole can slide into the battery compartment. The battery should snap into place.

Be sure to only use batteries with a well formed plus pole to ensure proper contact between the plus pole of the battery and the plus pole inside the battery compartment and also to ensure that the battery will not slide out of the battery compartment unintentionally.

Finally, close the battery lid by pushing the middle section. It should snap into the closed position.

To replace the batteries, open the battery lid as described above and pull the battery out of the battery compartment by pushing the battery towards the bottom until the plus pole is released and slides out.

ATTENTION! Never leave batteries inside the headphones for very long periods of time to prevent any damage to the headphones from leaking batteries. Dispose of spent batteries conforming to local waste Push disposal rules.

Push

1 Lift

2

3

 

 

 

Page 3

Page 4
Image 4
Amphony 1000 manual Installing the headphone batteries, Push, Lift, User and Installation Guide, Page