User and Installation Guide
Operating the headphones
R
After powering up the transmitter, the transmit light will light for approximately 5 seconds while the transmitter initializes.
After initialization, the transmit light will go out.
Once audio is detected at the audio input, the transmit light will light and the transmitter will transmit the audio signal.
Set the volume control of the headphones to minimum. Then, switch on the headphones and slowly increase volume.
After each use, be sure to switch off the headphones to extend battery life.
When no audio is present anymore, the transmitter will go into standby mode after approximately 1 minute. The transmit light will go out. During standby mode, no signal is transmitted. If the headphones are not used for an extended period of time, remove the AC adapter from the power outlet.
ATTENTION!
Listening over headphones at high audio levels can cause hearing impairments! Also, switching between different audio sources, connecting and disconnecting the transmitter, and the transmitter going into standby mode can cause loud clicks and pops which can impair your hearing! Therefore, always set the volume control to minimum.
Transmit light
2.4 GHz Digital Audio Transmitter
R
Page 4
