User and Installation Guide
Inserting the batteries into the headphones
R
After charging the batteries, insert them into the headphones.
There are two battery compartments, located on both sides, each housing one battery. To access each battery compartment, push on the outer edge of the battery lid. This will release the battery lid. Then lift the middle portion of the battery lid to gain access to the battery compartment.
Insert the battery by pressing the minus pole of the battery against the spring at the bottom of the battery compartment until the plus pole can slide into the battery compartment. The battery should snap into place.
Ensure that the plus pole of the battery properly contacts the battery contact inside the battery compartment to allow proper operation of the headphones. If necessary, rotate the battery inside the battery compartment until proper contact is established.
Finally, close the battery lid by pushing the middle section. It should snap into the closed position.
To remove the batteries, open the battery lid as described above and pull the battery out of the battery compartment by pushing the battery towards the bottom until the plus pole is released and slides out.
ATTENTION!
Never leave any batteries inside the headphones for very long periods of time to prevent any damage to the headphones from leaking batteries.
Push | 1 Lift | 2 | 3 |
|
|
|
Page 5
