User and Installation Guide
Operating the headphones
R
After powering up the transmitter, the transmit light will light for approximately 5 seconds while the transmitter initializes.
After initialization, the transmit light will go out.
Once audio is detected at any of the audio interfaces, the transmit light will light and the transmitter will transmit the audio signal.
By default (or if no audio is present), the transmitter will select the analog audio interface. As soon as a signal is detected at either one of the digital interfaces, the transmitter will activate the appropriate interface and light the corresponding interface indicator.
Set the volume control of the headphones to minimum. Then, switch on the headphones and slowly increase volume.
After each use, be sure to switch off the headphones to extend battery life and to prevent damage to the headphones from leaking batteries.
When no audio is present anymore, the transmitter will go into standby mode after approximately 1 minute. The transmit light will go out. During standby mode, no signal is transmitted. If the headphones are not used for an extended period of time, remove the AC adapter from the power outlet.
Interface indicators | Transmit light |
R
Page 6
