4081 User Manual | Issue 2 |
This block of switches may
be covered with a thin
protective film, which will
need to be carefully removed before attempting to set the switches.
For this switch, it is On when in the up position.
>Remove the lid to the unit, and set the 1st
Unit ID | Switch 1 | Switch 2 | Switch 3 |
9 | Off | Off | Off |
|
|
|
|
10 | On | Off | Off |
11 | Off | On | Off |
12 | On | On | Off |
13 | Off | Off | On |
14 | On | Off | On |
15 | Off | On | On |
16 | On | On | On |
|
|
|
|
If a unit's ID is changed, the power must be switched off and on again for the remote control software to receive the new ID number.
If the unit IDs are set incorrectly, they will either fail to respond or multiple units will respond to a single command.
Technical Earth
When switched on, internally connects zero volts to the unit chassis.
- 8 -