Installation
4Color Passive-Matrix LCD Touch Panels
6. Fasten the low-profile Back Box to the surface using the #6-32 machine screws supplied with
the enclosure.
7. Attach the data and power wiring to the touch panel.
8. Test the connection by reconnecting the AXlink connector to the Central Controller and
optional RS-232 wiring to the source equipment. Before continuing, disconnect all connections
until panel installation is complete. Once attached to the Decor style faceplate, the security
screws can’t be replaced without removing the overlay.
9. Fasten the touch panel and low-profile Back Box using the #6-32 machine screws supplied
with the enclosure panel.
10. Place the faceplate onto the bezel. You can also secure the faceplate to the bezel using the four
Phillips flat-head security screws.
11. Insert the engraved overlay back into the bezel.
12. Remove the backing from the adhesive tape strips located on the front of the touch panel; press
the engraved overlay onto the faceplate.
13. Reconnect the AXlink wiring to the Central Controller and RS-232 wiring (optional) to the
external RS-232 device. The touch panel beeps when you apply power.
Installing touch panels and a BB-TP2 Back Box (solid surface)
FIG.2 shows a sample AXD-CP/PB and BB-TP2 Back Box for solid surfaces.
The BB-TP2 can also be mounted to wood or metal studs using the pre-drilled stud mounting holes.
1. Cut out the surface using the dimensions shown in FIG.3.
FIG. 2 AXD-CP/PB and BB-TP2 Back Box (solid surfaces)
BB-TP2 Unimount
Backbox enclosure Knockout
Solid surface mounting flanges
Stud mounting
holes
Engraved overlay
AXD-CP/PB
faceplate