Installation
Installation
You can install the AV2SM on any flat surface that has unobstructed access to both the front and rear panel connectors.
Automatic and Manual Switching Mode Settings
You can select the switching mode by setting two internal jumpers on the circuit card inside the enclosure. You will need a Phillips screwdriver to open the enclosure. To set the switching mode:
1.Discharge the static electricity from your body and screwdriver.
2.Unplug all connectors from the front and rear panel of the AV2SM.
3.Turn the enclosure upside down and remove the two
4.Pull the enclosure apart and turn the bottom half, containing the circuit card,
5.Choose the desired switching mode:
!For automatic mode (FIG. 2), place the
E2 E1
AUTO
AUTO
MAN.
FIG. 2 Automatic mode settings
!For manual mode (FIG. 3), place the
E2 E1
AUTO
MAN..
FIG. 3 Manual mode settings
AV2SM A/V Switcher | 3 |
|
|
|
|
