AMX CB-TP15 specifications Surface, 93-032-10, REV a

	Stud
	Cable	C - Optional CB-TP
	knockouts	Rough-In Box
Mounting Tab
Install the four #4-40		Installed flush
screws into the places
		against the
indicated	SURFACE
		finished wall
		surface

Do not use these

tabs to mount the rough-in /wallbox These are ONLY used to

secure the main unit to the CB

B - Main NXD unit consists of

A - Faceplatethe touch panel and backbox housing (bezel)

FIG. 2 Wall Mount panel installation configuration for pre-existing Rough-In Box in a pre-wall construction

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s). 93-032-10 REV: A

10/08

©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.

AMX reserves the right to alter specifications without notice at any time.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com