HAVING TROUBLE W/ YOUR SOUND SYSTEM?
CONDITION | POSSIBLE CAUSE |
No Sound (Power LED Not Lit) | • turn POWER switch on |
| • plug in power cord |
| • check for blown fuse |
No Sound (Power LED Lights) | • check for output from source |
| • make sure all cables are completely plugged in |
| • increase volume control |
Distorted Sound | • check input cable connection |
| • lower input signal level |
Excessive Hum / Noise | • use shielded input cable |
Mic Volume Too Low | • set balanced input to |
Blows Fuse w/ Auxiliary Speaker | • shorted speaker cable |
Anchor Audio Customer Service
888-444-6077
www.anchoraudio.com
AN-1000X TECHNICAL SPECIFICATIONS
Rated Power Output | 50 watt continuous/90 watt dynamic | Inputs |
|
Max SPL @ Rated Power 103 dB @ 1 meter | Balanced | female XLR, switchable phantom | |
Frequency Response | 65 Hz – 20 kHz ±3dB |
| power, 15 volts DC @ 6.8 k ohm |
Speaker Type | 4.5” woofer w/ shielded magnet, | ||
| 10mm dome tweeter, | Bridging (10 k ohm) | |
| Line | ||
AC Power Reqs. | 110 - 125 VAC, 50/60 Hz | Outputs |
|
Export Model | 208 - 240 VAC, 50/60 Hz (90W max) | Line (post fader) | |
Dimensions (HWD) | 5.25 x 8.4 x 9” / 13 x 21 x 23 cm | Speaker | 8 ohm, unswitched, |
Weight | 9.5 lbs / 3.3 Kg | Sensitivity For Rated Output | |
Tone Controls |
| Line | balanced |
Bass | Microphone | balanced | |
Treble | Line |
(Specifications subject to change without notice)
Anchor Audio, Inc.AN-1000X
Portable Sound System
OWNER’S MANUAL
| CONTENTS |
GETTING STARTED | 2 |
FEEDBACK | 3 |
BASIC SYSTEM OPERATION | 4 |
BALANCED INPUT JACK | 4 |
6 | |
IMPORTANT SAFEGUARDS | 7 |
HAVING TROUBLE W/ YOUR SOUND SYSTEM? | 8 |
8 |
Portable Sound Systems • Torrance, California |