Anchor Audio AN-130 Diversity Wireless by Anchor Audio, Feedback, UHF Wireless Accessories

DIVERSITY WIRELESS BY ANCHOR AUDIO

Anchor Audio UHF wireless is a 16 channel, diversity wireless system that utilizes two independent antennae to receive signals. The diversity feature means the receiver will process the stronger of the two antenna signals, ef- fectively minimizing dropouts and interference from other transmitting sources. The antennae are mounted inter- nally so there are no obstructions or risk of damage.

FEEDBACK

Feedback is a howling noise or shrill sound that is self-generated by the sound system. It is caused by a micro- phone picking up the sound coming from the speaker and then being re-amplified. Once a feedback loop is started it will continue until the system is adjusted.

CHANNEL SELECTION - BUILT-IN RECEIVER

Before you can use your UHF wireless system, you will need to select a wireless frequency, set the built-in receiver, and microphone transmitter, to that channel.

1.Choose from any of the 16 available wireless channels

2.Set the wireless channel selector knob “CHANNEL” to the channel/frequency you have chosen

FEEDBACK CAUSES

•Microphone too close, pointing towards or in front of the speaker

•Volume setting too loud for room

•Sound reflections from hard surfaces, walls, etc.

AVOIDING & ELIMINATING FEEDBACK

•Point the microphone in a different direction

•Keep the microphone away from the speaker; position speaker in FRONT of microphone

•Reduce the sound system volume levels

If you have two wireless receivers repeat above for the second receiver. Remember each receiver/transmitter pair must be set to different channels to work properly.

CAUTION: Feedback can damage your equipment & may be hazardous to hearing.

	UHF WIRELESS
	VOLUME CONTROL
	UHF WIRELESS
	CHANNEL SELECTION
AN-130U1
BUILT-IN UHF WIRELESS
RECEIVER CONTROLS	RX INDICATOR LIGHTS

WIRELESS REMOTE CONTROL

REMOTE OPERATION (AN-130RC ONLY)

Point the red Mute button towards the front of the AN-130RC, aiming the remote at the red window located near the Volume and Tone controls.

•Raise volume by pressing Volume Up

•Lower volume by pressing Volume Down

•Mute system by pressing Mute

•Stop mute by pressing Mute again or pressing either volume button

VOLUME	MUTE
DOWN

VOLUME UP

NOTE: If you experience ongoing interference with your wireless system,

NOTE: If the system is not responding be sure the signal is not blocked.

the selected frequency may be incompatible w/ other systems in the area. Try different channels to find a clear frequency.

	UHF WIRELESS ACCESSORIES
WH-6000:	16 channel wireless handheld microphone/transmitter
WB-6000:	16 channel wireless body-pack transmitter for hands free microphone
	(microphone not included - see below)
CM-60:	Lightweight, low-profile collar microphone - works w/ the WB-6000 transmitter
EM-60:	UltraLite “Over-the-Ear” hands free microphone - works w/ the WB-6000 transmitter

REPLACING THE REMOTE BATTERY

1.Locate the latch on the bottom of the remote, near the back

2.Gently pull the latch towards the center of the remote

3.Slide out the battery holder carefully

4.Place a new battery in holder with positive symbol on the battery facing up

5.Carefully re-insert the battery holder

REMOTE CONTROL BOTTOM

BATTERY

BATTERY

HOLDER

	LM-60:	Lightweight, clip-on lapel microphone - works w/ the WB-6000 transmitter
6	HBM-60:	Ultra-lightweight headband microphone - works w/ the WB-6000 transmitter

NOTE: Use only CR2025 or CR2032 type batteries.

3