Andrew 5.6-Meter ESA manual Step

Step 5

Step 6

Attach 201314 supports to 201301/201302 rear pad assemblies and 201273 joint assembly as shown in Figure 9.

•Use 7/8 x 2-1/4 in (57 mm) bolts and nuts

•Insert bolt from inside of joint assembly to outside of support

•Supports should be installed back-to-back with the edges forward and the flats of angles facing rear

Figure 9

Attach 201317 supports between angle pairs as shown in Figure 10. Select correspond- ing mounting holes so that 201317 supports are parallel to 201313 beam assembly.

•Use 7/8 x 2-1/4 in (57 mm) hardware

•Supports attached with edges inward and flats facing up.

Figure 10

15 Installation Procedures