+12 VOLT RAIL DISTRIBUTION
The CP-1000 uses four separate +12 volt power rails. Different connectors are hooked up to separate circuits to aid in the balanced distribution of power between devices in your computer. The engineers have allocated the rails to different connectors, as shown in Table 3, to prevent voltage sags in one device due to sudden demands for power by another device.
TABLE 3
PSU Direct Cabling Connector
(20+4) Motherboard
4+4-pin ATX12V, EPS
8-pin EPS12V
PCI-E w/ blue stripe
PCI-E w/ green stripe
Molex cable from PSU
SATA cable from PSU
INSTALLATION:
1.Remove the standard PSU adapter from the Antec case to allow the larger PSU to fit.
2.Install the CP-1000 PSU into your case with the four screws provided.