Antec Fusion Remote Black user manual Installing the Power Supply, Connecting the Switches and LED

2.Make sure you have the correct I/O panel for your motherboard. If the panel provided with the case isn’t suitable, please contact your motherboard manufacturer for the correct I/O panel.

3.Line up your motherboard with the standoff holes, and remember which holes are lined up. Not all motherboards will match with all the provided holes; this is normal and won’t affect functionally.

4.Remove your motherboard by lifting it up.

5.Screw the brass standoffs into the threaded holes that line up with your motherboard. Do not over-tighten the standoffs. Some standoffs may be pre-installed for your convenience.

6.Place your motherboard on the brass standoffs.

7.Screw in your motherboard to the standoffs with the provided Philips-head screws. Your motherboard is now installed.

Installing the Power Supply

1.Set it on the four rubber pads at the bottom of the PSU chamber. Note: Fusion Remote provides mounting holes for power supplies with standard mounting layouts to be installed upside up or upside down.

2.Push the power supply to the back of the case and align the mounting holes.

3.Secure the power supply to the case with the screws provided.

4.Loosen the screw on the sliding black plate and widen the opening so you can feed the necessary power cables through to the other side.

5.Slide the plate back to constrict the opening and secure it with the screw, so that the airflow in the case works as designed.

Connecting the Switches and LED

1.Connect the Reset switch (labeled RESET SW) to the motherboard at the RST connector. Polarity (positive and negative) does not matter for switches.

2.Connect the Power Switch (labeled POWER SW) from the front LCD display to the PWR connector on the motherboard.

Note: The Power Switch from the front I/O is connected to the LCD display module by default. This will allow you to turn your system on and off using the remote control. If you choose to connect the Power Switch from the front I/O directly to the motherboard instead of via the LCD display, you won’t be able to control system power using the remote control.

3.The Power LED (labeled POWER LED) connector is located behind the Reset connector. For LEDs, colored wires are positive (+). White or black wires are negative (–). If the LED does not light up when the system is powered on, try reversing the connection. For more info on connecting LEDs to your mother- board, see your motherboard manual.

4.The Hard Drive LED (labeled HDD LED) connects to the hard drive activity header on your motherboard or RAID card.

Connecting the USB Ports

You will find a single 10-pin connector on a cable attached to the front USB ports. This is an Intel® standard connector that is keyed so that it can’t be accidentally reversed when connected to a proper Intel® standard motherboard header. Connect the 10-pin connector to the motherboard headers so that the blocked pin fits over the missing header pin.

Note: Please check the motherboard manual for the USB header pin layout and make sure it matches the following table.

2