Attaching the screwless Drive Rails.
Figure 1. Figure 2.
Data Cable Connection
After you have connected the devices to the power supply, you need to connect the data
cables between the devices and the motherboard. The data cables are not included with the
case; we include this information only as an aid.
1. For hard drives and CD-ROM's, use the 40-pin IDE ribbon cables. For floppy drives,
use the 34-pin floppy ribbon cables. These should come with your devices and have a
red stripe one on side indicating pin number 1. When you connect a ribbon cable to a
device, make sure that the red stripe is on pin 1 of the device, usually toward the
power connector.
2. The side that attachs to devices should be the side that has 2 connectors. This will
enable you to connect another device if you wish.
3. Connect the far end of the cable to your motherboard on the IDE port, either IDE 1 or
IDE 2, or the FLOPPY port.
Fan Installation
The case has one optional 80mm cooling fan mount in the rear and one optional 80mm
cooling fan in the front.
The rear fan should be installed so that the air is blowing out of the case.
1. Attach the fan with screws into the rear fan mount.
2. Connect a large 4-pin white connector from the power supply to the male 4-pin
connector on the fan.
The front fan should be installed so that the air is blowing into the case from the front.
1. Squeeze the tabs on the fan cage to release it.
2. Drop the fan into the cage and push it in until it snaps in.
3. Snap the cage with fan back into its place.
4. Connect a large 4-pin white connector from the power supply to the male 4-pin
connector on each of the fans.
Antec Quality 3-Year parts and labor warranty (A3Q)
See details at:
http://www.antec-inc.com/support_warranty.html
http://www.antec-europe.com/warranty_uk.html
45