Anton/Bauer 2400 Safeguards, Grounding/Earthing, Fuse TYPE/REPLACEMENT, Operation, Self-Test

SAFEGUARDS

Power Sources: This unit was designed to operate at mains voltages from 90 to 250 Volts AC, 50-60 Hz.

Risk of Electrical Shock: Refer servicing to qualified service personnel.

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

GROUNDING/EARTHING

IMPORTANT WARNING: THIS APPARATUS MUST BE EARTHED.

To ensure safe operation, the three pin plug supplied must be inserted only into a standard three-pin power point which is effectively grounded through the normal household wiring. Extension cords used with the equipment must be three-conductor and be correctly wired to provide connection to earth ground. Improperly wired extension cords are a dangerous electrical hazard.

The fact that the equipment operates satisfactorily does not imply that the power point is properly grounded and that the installation is completely safe. If any doubt exists about the correct grounding of the power point, consult a qualified electrician.

IMPORTANT: The wires in this main lead are colored in accordance with the following code:

Green and yellow	Earth
Blue	Neutral
Brown	Live

FUSE TYPE/REPLACEMENT

The mains input of the PowerCharger is fused using a printed circuit board mounted device which should be replaced ONLY by a qualified service technician.

OPERATION

Self-Test

Upon applying mains power, each PowerCharger will initiate a self-test mode. This mode is indicated in the LCD, by an audible alert and the lighting of each LED on the PowerCharger (and any charge module attached) in sequence. Upon completion of the self-test, the green status light will light steadily, indicating that the unit is ready for operation.

NOTE: Mount batteries to the charger or any charge expansion module attached only when the PowerCharger has completed its self-test mode. Disconnect the camera cable from the 4 Pin XLR Connector located on the back of the PowerCharger.

3