Anton/Bauer DUAL 2702, QUAD 2702 owner manual Wait 2-READY 3-CHARGE 4-READY, Propac, Vco

LCD Indications

Each PowerCharger’s liquid crystal display (LCD) will display the status of each battery, as well as, important PowerCharger operating indications. The following information explains the indications which appear in the LCD.

The levels of the LCD display on each PowerCharger can be obtained by pressing the DISPLAY, or in some cases TEST, button on the PowerCharger front panel.

1 - - - - - - - 2 - - - - - - -

The Main Display shows the general status of each battery mounted to the PowerCharger. This display is immediately returned to following self test and after viewing any other screen.

1 - - - - - - -	2 - - - - - - -
3 - - - - - - -	4 - - - - - - -

Both the two position (above) and four position Main Displays will show a series of dashes when a battery has not been mounted to the PowerCharger.

1—WAIT 2—READY 3—CHARGE 4—READY

The Main Display of the PowerCharger will show the abbreviated status of each battery on the main unit.

DUAL 2701 Rev. #3.xx

Discharger NOT INSTALLED

The Signature Display can be viewed by pressing and holding the TEST button from the Main Display on the PowerCharger to obtain model information, Software revision number and installation of DDM (discharger).

1—Waiting to Charge

PROPAC 14 16.5 V

The Primary Position Display is obtained by pressing the DISPLAY button repeatedly until the position number for the battery desired is displayed. This view further identifies the status of the battery, its model number (chemistry and voltage), as well as current battery voltage.

2—READY (Lifesaver) 4.0 PROPAC 14D 100% 16.5 V

The Primary Position Display will additionally display the available capacity when a DIGITAL

battery is used, both in percent and in ampere hours.

2—Ser# 96280 Mar98		4.0
118 cycles	VCO	27oC

The Secondary Position is obtained by pressing and holding the DISPLAY button while viewing the primary position display. This Secondary display is available only with DIGITAL batteries and is used to obtain information transmitted from the battery to the charger including battery serial number, date of manufacture, number of cycles, “learned” capacity, type of stage one charging cut-off experienced and battery temperature.

6