U
Us
se
er
r
M
Ma
an
nu
ua
al
l
P
Pa
ag
ge
e
3
30
0
o
of
f
3
37
7

To Set User Status

1. Select Skype under menu mode;
2. Select < User Status > under Skype mode;
3. Press Left key, then the display shows the selection status;
4. Press Scrolling button to select the status you wish to set;
5. Press Left key to save.
Resetting the system
If you have set a PIN and forgotten it, you need to reset the system. The PIN will be reset
to 0000. If you reset the system, you will lose all stored information (including numbers
in memory) and all features will return to their default settings. You need to register the
handset to the base unit again.
While you are resetting the system, you should disconnect the telephone line cord from
the back of the base unit, so you won't be interrupted by incoming calls. To reset the
system without the PIN:
1. Disconnect the power lead from the back of the base unit
2. Press and hold the HANDSET LOCATOR button in the base unit, at the
same time connect the power lead into the back of base unit. Release the
LOCATOR button after you hear “beep” sound for five times. The IN USE light
on base unit lights during this whole process.
3. After 2~3 seconds, you can hear “beep” sound for two times again and the IN
USE light goes off;
4. Disconnect the power lead from base. Reconnect and you will hear a confirmation
tone from the base unit.
Intercom and transfer

To Make an Intercom Call

1. Press the INT key. You hear Dial tone