APC 66123 installation manual IP Settings

The Network Management Card & Modbus/Jbus (66123) can be hot-plugged in MGETM GalaxyTM 7000 equipped with a Minislot. It is not necessary to shutdown the UPS, disconnect the load or restart the UPS.

◗Note the MAC address of the card before inserting it.

UPS

Settings/Sensor

66103

ETHERNET

◗Insert and secure the card with the screws.

◗Connect the ETHERNET cable.

◗Check the ETHERNET port indications.

◗Wait until the UPS Data LED flashes regularly (approx. two minutes), indicating that card start-up has terminated correctly.

Note. Connection detection continues until the card has been connected to the network. Once connection is made, card start-up continues.

IP SETTINGS

Once the card has started, proceed as indicated below.

◗Connect the serial cable to card’s service port and PC’s COM port

◗Use a terminal emulator such as HyperTerminalTM with these settings

Bits per second	Data bits	Stop bits	Parity	Flow control
9600	8	1	none	none

"Echo typed characters locally" option: disabled

◗Type MGEUPS (or mgeups).

The main configuration menu is displayed:

APC by Schneider Electric

Network Management Card & Modbus/Jbus Release : AB.build_5_0_7

1 : Reset

2 : Network configuration

3 : Set Login Password to Default

4 : Return to Default Configuration

5 : Jbus configuration

6 : Sensor configuration

0 : Exit

3402230800/AC - 5