Connecting dry contact devices to the Zone A and B terminals on the screw terminal block

The sensing voltage available on the Zone A and B pins of the Dry Contact I/O Accessory is nominally 5 Vdc at less than 1 mA, referenced to system ground.

Connecting a device to the power output (Pwr) terminals on the screw terminal block

You can use the NO/GND terminal on the screw terminal block to connect Normally Open (NO) dry contact devices and to connect a device to the power output (Pwr) terminals.

2

Dry Contact I/O Accessory (AP9810) Technical Guide

Page 2
Image 2
APC manual Dry Contact I/O Accessory AP9810 Technical Guide