Installation
1. Use the Torx T30/#2 Phillips wrench (provided) to adjust a vertical mounting flange. Remove the T30 screws at the top, middle, and bottom of the vertical mounting flange. Save the screws for adjustment and reinstallation in the new position.
600 mm cabinet | 800 mm cabinet |
|
ns2014a
CAUTION
STABILITY HAZARD
When adjusting vertical mounting flanges, ensure that no equipment is installed on the vertical mounting flanges.
Failure to follow these instructions can result in injury or equipment damage.
NOTICE
•Vertical mounting flange attachment positions are in 10 mm (0.4 in.) increments.
•If the vertical mounting flanges are adjusted from their factory mounting position more than 60 mm (2.4 in.), the vertical mounting flanges attach to the cabinet side brace using cage nuts and fasteners.
ns2030a
NetShelter SV User Manual | 15 |
