APC BX1300G, BN1350G, BX1500G warranty Feature Quick-Reference, Protection outlets, Master/Enable

Feature Quick-Reference

Function

Button

Timing UPS Description (seconds) Status

Power

POWER ON

POWER OFF

Display

0.2	Off	Press the POWER ON/OFF button to turn on the Back-UPS and operate on
		AC power.
		If AC input power is not available the Back-UPS will operate on battery
		power.
2	On	Press the POWER ON/OFF button to turn off the Back-UPS.
		The Back-UPS will continue to provide surge protection to the Surge
		Protection outlets.

Status Inquiry	0.2	On	Verify the status or condition of the Back-UPS. The LCD will illuminate
			for 60 seconds.
Power-Saving mode:	2	On	The LCD will illuminate and the Back-UPS will beep to confirm
Continuous			Continuous Illumination mode is activated.
Illumination			The LCD will extinguish and the Back-UPS will beep to confirm that
			Power-Savingmode is activated. While in Power-Savingmode, the
			LCD will illuminate if a button is pressed, then extinguish after 60
			seconds of no activity.
Mute
Event Specific	0.2	On	Disable any audible alarms caused by an event.
General Status	2	On	Enable or disable the audible alarms. The Mute icon will illuminate and
Enable/Disable			the Back-UPS will beep one time. The Mute feature will not activate
			unless the Back-UPS is operating on battery power.
Sensitivity	6	Off	The Load Capacity icon will flash to indicate the Back-UPS is in
			Program mode. Use the POWER ON/OFF button to scroll through and
			select Low, Medium, and High sensitivity levels. The Back-UPS will
			beep to confirm the selection. Refer to “Back-UPS sensitivity settings” on
			page 4 for details.
MASTER/	2	On	The leaf icon will extinguish to indicate the MASTER outlet feature is
CONTROLLED			disabled or illuminate to indicate the MASTER outlet feature is enabled.
outlet Enable/			The Back-UPS will beep once.
Disable
Master/Enable	6	On	While calibrating the threshold setting, the device connected to the
threshold calibration			MASTER outlet should be turned off or placed in Standby or Sleep mode.
			Once the threshold setting has been selected the Power-Savingicon will
			flash 3 times and beep 3 times.
Self-Test (manual)	6	On	The Back-UPS will run a test of the internal battery.
			Note: This will happen automatically when the Back-UPS is turned on.
Event Reset	0.2	On	When the Event screen is visible, press and hold DISPLAY, then press the
			POWER button to clear the AC failure event counter.
Fault Reset	2	Fault	After a fault has been identified, press the POWER ON/OFF button to
			remove the visual indication and return to standby status.

Installation and Operation Back-UPS BX1300G/BN1350G/BX1500G 7