APC BN1350G, BX1300G, BX1500G warranty Modes of operation, Status indicators, System faults

Modes of operation

Press DISPLAY to scroll through the display screens.
	On Line Mode	On Battery Mode
	Input Voltage	Estimated runtime in minutes
	Counter	Power Event Counter
	Estimated run time	Output Voltage
	Load in Watts	Input Voltage
	Load in %	Load in Watts
	Output Voltage	Load in %
	Output Frequency	Output Frequency

Status indicators

Status	LED	Audible Alarms	Audible Alarm Terminates
Overload		Constant tone	The alarm stops when nonessential
An overload condition has occurred			equipment is disconnected from the
while operating on AC or battery power.			Battery Backup outlets or the Back-UPS
			is turned off.
On Battery		Beeps 4 times every 30	The beeping stops when AC power is
The Back-UPS is supplying battery		seconds.	restored or the Back-UPS is turned off.
power to the Battery Backup outlets.
Low Battery		Continuous beeping	The beeping stops when AC power is
The Back-UPS is supplying battery			restored or the Back-UPS is turned off.
power to the Battery Backup outlets and
the battery is near a total discharge state.

System faults

bu088a

F01	On-Battery Overload	Turn the Back-UPS off. Disconnect non-essential
		equipment from the Battery Backup outlets and then
		turn Back-UPS on.
F02	On-Battery Output Short	Turn the Back-UPS off. Disconnect non-essential
		equipment from the Battery Backup outlets and then
		turn Back-UPS on.
F03	On-Battery Xcap Overload	Faults F03-F09 are not user serviceable. Contact APC
F04	Clamp Short	Technical Support for assistance.
F05	Charge Fault
F06	Relay Welding
F07	Temperature
F08	Fan Fault
F09	Internal Fault

6 Installation and Operation Back-UPS BX1300G/BN1350G/BX1500G