Note: To reach the SCSI cable connector on the back hard drive, you may need to remove the carrier. If so, use a Phillips screwdriver to remove the mounting screw that holds the carrier to the chassis. Then pull the carrier lever forward and slide up the carrier to disconnect it from the chassis. (Figure 4)
Figure 4
3. Disconnect the SCSI cable from the SCSI terminator at the bottom of the chassis.
Installing the Replacement SCSI Cable
1.Connect the SCSI cable to all drives.
2.Reinstall the back hard drive carrier, if necessary.
3.Connect the SCSI cable to the SCSI card.
4.Anchor the
Power Mac G4 (Mirrored Drive Doors) SCSI Cable - 4
